Brocade 6910 Ethernet Access Switch Configuration Guide (S Manual do Utilizador descarregar pdf (Página 90)

34 Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

Entering Commands

To enter the other modes, at the configuration prompt type one of the following commands. Use the

exit or end command to return to the Privileged Exec mode.

For example, you can use the following commands to enter interface configuration mode, and then

return to Privileged Exec mode

Console(config)#interface ethernet 1/5

Console(config-if)#exit

Console(config)#

Command Line Processing

Commands are not case sensitive. You can abbreviate commands and parameters as long as they

contain enough letters to differentiate them from any other currently available commands or

parameters. You can use the Tab key to complete partial commands, or enter a partial command

followed by the “?” character to display a list of possible matches. You can also use the following

editing keystrokes for command-line processing:

TABLE 6 Configuration Command Modes

Mode Command Prompt Page

Access Control

List

access-list arp

access-list ip standard

access-list ip extended

access-list ipv6 standard

access-list ipv6 extended

access-list mac

Console(config-arp-acl)

Console(config-std-acl)

Console(config-ext-acl)

Console(config-std-ipv6-acl)

Console(config-ext-ipv6-acl)

Console(config-mac-acl)

250

234

240

245

CFM ethernet cfm domain Console(config-ether-cfm) 524

Class Map class-map Console(config-cmap) 428

ERPS erps domain Console(config-erps) 357

Interface interface {ethernet port | port-channel id| vlan id} Console(config-if) 256

Line line {console | vty} Console(config-line) 75

MSTP spanning-tree mst-configuration Console(config-mstp) 335

Policy Map policy-map Console(config-pmap) 431

Time Range time-range Console(config-time-range) 101

VLAN vlan database Console(config-vlan) 375

TABLE 7 Keystroke Commands

Keystroke Function

Ctrl-A Shifts cursor to start of command line.

Ctrl-B Shifts cursor to the left one character.

Ctrl-C Terminates the current task and displays the command prompt.

Ctrl-E Shifts cursor to end of command line.

Ctrl-F Shifts cursor to the right one character.

Ctrl-K Deletes all characters from the cursor to the end of the line.

Ctrl-L Repeats current command line on a new line.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 123 124

Comentários a estes Manuais

Sem comentários

Brocade 6910 Ethernet Access Switch Configuration Guide (S Manual do Utilizador Página 90

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para Computador Brocade 6910 Ethernet Access Switch Configuration Guide (S