Brocade Multi-Service IronWare Multicast Configuration Gui Manual do Utilizador descarregar pdf (Página 102)

90 Multi-Service IronWare Multicast Configuration Guide

53-1003032-02

PIM Anycast RP

Brocade(config-pim-router)#ip access-list standard my-anycast-rp-set

Brocade(config-std-nacl)#permit host 1.1.1.1

Brocade(config-std-nacl)#permit host 2.2.2.2

Brocade(config-std-nacl)#permit host 3.3.3.3

The RP shared address 100.1.1.1 is used in the PIM domain. IP addresses 1.1.1.1, 2.2.2.2, and

3.3.3.3 are listed in the ACL that forms the self inclusive Anycast RP set. Multiple anycast-rp

instances can be configured on a system; each peer with the same or different Anycast RP set.

NOTE

The PIM software supports up to eight PIM Anycast-RP routers. All deny statements in the

anycast_rp_set acl and additional routers more than eight listed in an access list are ignored.

Example

The example shown in Figure 12 is a PIM Anycast-enabled network with 3 RPs, 1 PIM-FH router

connecting to its active source and local receiver. Loopback 2 in RP1, RP2, and RP3 have the same

IP addresses 100.1.1.1. Loopback 3 in RP1, RP2, and RP3 each have separate IP addresses

configured to communicate with their peers in the Anycast RP set.

FIGURE 12 Example of a PIM Anycast RP network

Displaying information for a PIM Anycast RP interface

To display information for a PIM Anycast RP interface, enter the following command.

Brocade(config)#show ip pim anycast-rp

Number of Anycast RP: 1

Anycast RP: 100.1.1.1

ACL ID: 200

ACL Name: my-anycast-rp-set

ACL Filter: SET

Peer List:

1.1.1.1

2.2.2.2

3.3.3.3

Syntax: show ip pim anycast-rp

The following table describes the parameters of the show ip pim anycast-rp command:

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 215 216

Sem comentários

Brocade Multi-Service IronWare Multicast Configuration Gui Manual do Utilizador Página 102