Brocade Multi-Service IronWare Multicast Configuration Gui Manual do Utilizador Página 128
- Página / 216
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
116 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
IGMP V3
1
The vrf parameter specifies that you want to display IGMP interface information for the VRF
specified by the vrf-name variable.
Enter ve and its number, or ethernet and its slot/port to display information for a specific virtual
routing interface, or ethernet interface.
The tunnel num parameter specifies a GRE tunnel interface that is being configured. The GRE
tunnel interface is enabled under the router PIM configuration.
Entering an address for group-address displays information for a specified group on the specified
interface.
The report shows the following information:
Displaying IGMP traffic status
To display the traffic status on each virtual routing interface, enter the following command.
Syntax: show ip igmp [vrf vrf-name] traffic
This field Displays
Intf The virtual interface on which IGMP is enabled.
Port The physical port on which IGMP is enabled.
Groups The number of groups that this interface or port has membership.
Version
Oper The IGMP version that is operating on the interface.
Cfg The IGMP version that is configured for this interface.
Querier Where the Querier resides:
The IP address of the router where the querier is located
or
Self – if the querier is on the same router as the intf or port.
Max response
oQrr Other Querier present timer.
GenQ General Query timer
V1Rtr Whether IGMPv1 is present on the intf or port.
V2Rtr Whether IGMPv2 is present on the intf or port.
Tracking Fast tracking status:
Enabled
or
Disabled
Brocade# show ip igmp traffic
Recv QryV2 QryV3 G-Qry GSQry MbrV2 MbrV3 Leave IsIN IsEX ToIN ToEX ALLOW BLK
v5 29 0 0 0 0 0 0 0 0 0 0 0 0
v18 15 0 0 0 0 30 0 60 0 0 0 0 0
v110 0 0 0 0 0 97 0 142 37 2 2 3 2
Send QryV1 QryV2 QryV3 G-Qry GSQry
v5 0 2 0 0 0
v18 0 0 30 30 0
v110 0 0 30 44 11
- Multi-Service IronWare 1
- Document History 2
- Contents 3
- About This Document 7
- Supported software 8
- Document conventions 9
- Notice to the reader 10
- Related publications 10
- In this chapter 11
- Overview of IP multicasting 15
- VRF CAM entries 18
- Mtrace overview 20
- Mtrace components 21
- Configuring mtrace 22
- System max parameter changes 23
- Multicast non-stop routing 25
- IP multicast boundaries 28
- FIGURE 2 LSP path topology 30
- Limitations 31
- Enabling RPF shortcut feature 31
- Multicast ECMP support 32
- Limitations and prerequisites 34
- Enabling Multicast ECMP 35
- Enabling Rebalance 35
- PIM Dense 36
- Grafts to a multicast tree 39
- PIM DM versions 39
- Configuring PIM DM 40
- Modifying the TTL threshold 44
- Multicast PIM neighbor filter 50
- Limitation and prerequisites 51
- PIM Sparse 52
- PIM Sparse device types 53
- • Disables PIM or DVMRP 55
- Configuring RPs 56
- ACL based RP assignment 58
- Displaying the static RP 59
- Brocade(config)# router pim 62
- PIM multinet 63
- Displaying PIM counters 80
- • Group address: 232.1.0.95 82
- • RP address: 206.251.17.41 82
- Source Active caching 83
- Configuring MSDP 83
- Disabling an MSDP peer 84
- Displaying MSDP information 88
- Syntax: show ip msdp peer 89
- MSDP peer information 89
- Displaying MSDP RPF-Peer 93
- Displaying MSDP Peer 93
- Displaying MSDP VRF RPF-Peer 93
- Clearing MSDP information 94
- Configuring MSDP mesh groups 95
- Configuring MSDP mesh group 96
- MSDP Anycast RP 97
- RP 1 configuration 99
- RP 2 configuration 99
- MSDP Anycast RP 100
- PIMR1 configuration 100
- PIMR2 configuration 100
- PIM Anycast RP 101
- Example 102
- DVMRP overview 103
- Pruning a multicast tree 104
- Configuring DVMRP 105
- Brocade(config)# router dvmrp 106
- Brocade(config-dvmrp-router)# 106
- Brocade(config)# int e 3/1 106
- Modifying neighbor timeout 107
- Modifying route expires time 107
- Modifying route discard time 107
- Modifying prune age 107
- Modifying probe interval 108
- Modifying report interval 108
- Modifying trigger interval 108
- Modifying default route 108
- Displaying DVMRP information 109
- • DVMRP neighbor information 110
- • Ethernet 111
- • Disabled 111
- • Enabled 111
- Field Description 112
- This field... Displays 113
- 53-1003032-02 118
- Brocade(config)# vrf vpn1 119
- Brocade(config)# write memory 120
- Default IGMP version 121
- Creating a static IGMP group 124
- Setting the query interval 124
- Displaying IGMPv3 information 125
- This field Displays 126
- Displaying static IGMP groups 127
- Source-specific multicast 130
- Configuration Considerations 131
- IGMPv2 SSM mapping 132
- Configuration requirements 135
- Changing the IGMP mode 136
- Modifying the query interval 137
- Modifying the age interval 137
- Filtering multicast groups 137
- PIM SM traffic snooping 138
- Configuration Notes 142
- Application example 142
- Multicast Traffic Forwarding 143
- IP Multicast CPU Protection 146
- Verifying CPU protection 147
- Static IGMP membership 148
- Brocade(config)# vlan 100 150
- Clearing IGMP group flows 155
- Commands 156
- Release Command History 157
- IPv6 PIM Sparse 163
- PIM Sparse router types 164
- RP paths and SPT paths 165
- Configuring PIM Sparse 165
- IPv6 PIM-Sparse mode 166
- Configuring BSRs 166
- Configuring candidate RP 168
- Statically specifying the RP 168
- Embedded Rendezvous Point 169
- • Default route from the mRTM 171
- • Default route from the uRTM 171
- Setting the inactivity timer 174
- Changing the hello timer 174
- Configuring a DR priority 175
- Configuring PMRI 176
- Displaying hardware-drop 176
- Displaying BSR information 180
- Displaying the RP set list 183
- Displaying IPv6 PIM RPF 187
- Displaying IPv6 PIM counters 187
- Configuring PIM Anycast RP 192
- Enabling MLDv2 194
- Setting the robustness 197
- Setting the version 197
- Specifying a port version 197
- Displaying MLD information 198
- • The port ID 200
- • The multicast protocol used 200
- Displaying MLD settings 201
- Displaying static MLD groups 202
- Displaying MLD traffic 202
- Clearing IPv6 MLD traffic 203
- Configuring IPv6 MLD snooping 205
- Changing the MLD mode 205
- PIM-SM traffic snooping 206
- Application examples 207
- Setting the MLD version 210
Manuais e produtos relacionados com Acessórios para Computador Brocade Multi-Service IronWare Multicast Configuration Gui
Acessórios para Computador Brocade NetIron CER 2000 Series Hardware Guide (Supporting Manual do Utilizador
(110 páginas)
(110 páginas)
Acessórios para Computador Brocade Multi-Service IronWare Routing Configuration Guide Manual do Utilizador
(846 páginas)
(846 páginas)
Acessórios para Computador Brocade ICX 6610 Stackable Switch Hardware Installation Gu Manual do Utilizador
(108 páginas)
(108 páginas)
Acessórios para Computador Brocade ICX 6450 Stackable Switches Hardware Installation Manual do Utilizador
(116 páginas)
(116 páginas)
Acessórios para Computador Brocade Multi-Service IronWare Administration Guide (Suppo Manual do Utilizador
(432 páginas)
(432 páginas)
Acessórios para Computador Brocade Converged 10GbE Switch Module for IBM BladeCenter Manual do Utilizador
(12 páginas)
(12 páginas)
Acessórios para Computador Brocade ICX 6430-C Compact Switch Hardware Installation Gu Manual do Utilizador
(64 páginas)
(64 páginas)
Acessórios para Computador Brocade ICX 6450-C Compact Switch Hardware Installation Gu Manual do Utilizador
(64 páginas)
(64 páginas)
Acessórios para Computador Brocade Multi-Service IronWare Multiprotocol Label Switch Manual do Utilizador
(852 páginas)
(852 páginas)
Acessórios para Computador Brocade FCoE Switch Module for IBM BladeCenter Installatio Manual do Utilizador
(76 páginas)
(76 páginas)
Acessórios para Computador Brocade FastIron WS Hardware Installation Guide Manual do Utilizador
(74 páginas)
(74 páginas)
Acessórios para Computador Brocade TurboIron 24X Series Hardware Installation Guide Manual do Utilizador
(84 páginas)
(84 páginas)
Acessórios para Computador Brocade FastIron SX Series Chassis Hardware Installation G Manual do Utilizador
(192 páginas)
(192 páginas)
Acessórios para Computador Brocade Access Gateway Administrator's Guide (Support Manual do Utilizador
(0 páginas)
(0 páginas)
Acessórios para Computador Brocade Encryption Switch Hardware Reference Manual (Suppo Manual do Utilizador
(60 páginas)
(60 páginas)
Acessórios para Computador Brocade Encryption Switch QuickStart Guide (Supporting Fab Manual do Utilizador
(20 páginas)
(20 páginas)
Acessórios para Computador Brocade Unified IP MIB Reference (Supporting FastIron Rele Manual do Utilizador
(768 páginas)
(768 páginas)
Acessórios para Computador Brocade TurboIron 24X Series Configuration Guide Manual do Utilizador
(111 páginas)
(111 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.118 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais