Brocade Multi-Service IronWare Routing Configuration Guide Manual do Utilizador descarregar pdf (Página 312)

100

101

284 Multi-Service IronWare Routing Configuration Guide

53-1003033-02

IS-IS Non-Stop Routing

Second-wait This fields indicates the wait time between the first and second PSPF

calculations. If this optional value is configured, it will be doubled with

each PSPF recalculation until the value is equal to the max-wait value

This value reflects the second-wait variable that is configured using the

partial-spf-interval command as described in “Configuring the IS-IS PSPF

exponential back-off feature” on page 263.

PSPF run status. This field is not specifically labeled but it is displayed directly under the

PSPF timers. It can be any of the three values shown below:

• PSPF is running

• PSPF will run in sec where the sec variable is a value in seconds

until the next time that PSPF will be run.

• PSPF is not scheduled

Timers: LSP:

max-lifetime This fields indicates the maximum number of seconds an unrefreshed

LSP can remain in the Brocade device’s LSP database.

The default value is 1000 sec.

refresh-interval This fields indicates the maximum number of seconds that a Brocade

device waits between sending updated LSPs to its IS-IS neighbors.

The default value is 1 sec.

gen-interval This fields indicates the minimum number of seconds that a Brocade

device waits between sending updated LSPs to its IS-IS neighbors.

The default value is 10 sec.

retransmit-interval This fields indicates the amount of time the Brocade device waits before

it retransmits LSPs.

The default value is 5 sec.

lsp-interval This fields indicates the rate of transmission (in milliseconds) of the

LSPs.

The default rate is 33 ms.

Timers: SNP:

csnp-interval This fields indicates how often the designated IS sends a CSNP to the

broadcast interface.

The default value is 10 sec.

psnp-interval This fields indicates how often the IS sends a PSNP.

The default value is 2 sec.

Global Hello Padding The value can be:

• Enabled

• Disabled

Global Hello Padding For Point to Point

Circuits

The value can be:

• Enabled

• Disabled

Ptpt Three Way HandShake Mechanism The value can be:

• Enabled

• Disabled

IS-IS Traffic Engineering Support The value can be:

• Enabled

• Disabled

TABLE 38 Output from the show isis command (Continued)

This field... Displays...

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 845 846

Comentários a estes Manuais

Sem comentários

Brocade Multi-Service IronWare Routing Configuration Guide Manual do Utilizador Página 312

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para Computador Brocade Multi-Service IronWare Routing Configuration Guide