Brocade Multi-Service IronWare Routing Configuration Guide Manual do Utilizador Página 405

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 846
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 404
Multi-Service IronWare Routing Configuration Guide 377
53-1003033-02
Configuring Multi-VRF
Brocade(config)# router ospf
Brocade(config-ospf-router)# area 0
Brocade(config-ospf-router)# redistribution connected
Brocade(config-ospf-router)# exit
Brocade(config)# interface loopback 1
Brocade(config-lbif-1)# ip address 10.1.2.1/32
Brocade(config-lbif-1)# ip address 10.1.3.1/32
Brocade(config-lbif-1)# interface ethernet 1/1
Brocade(config-if-e1000-1/1)# ip ospf area 0
Brocade(config-if-e1000-1/1)# ip address 10.1.1.2/24
CE 3 and CE 4 configurations
The CE3 and CE4 router configurations are exactly the same. Both are configured in OSPF Area 0
with route redistribution enabled. The IP addresses: 10.2.2.1/32 and 10.2.3.1/32 are configured
for the Loopback1 interface allowing them to carry routes from these networks.
Brocade(config)# router ospf
Brocade(config-ospf-router)# area 0
Brocade(config-ospf-router)# redistribution connected
Brocade(config-ospf-router)# exit
Brocade(config)# interface loopback 1
Brocade(config-lbif-1)# ip address 10.2.2.1/32
Brocade(config-lbif-1)# ip address 10.2.3.1/32
Brocade(config-lbif-1)# interface ethernet 1/1
Brocade(config-if-e1000-1/1)# ip ospf area 0
Brocade(config-if-e1000-1/1)# ip address 10.2.1.2/24
Configuration 2
As shown in Figure 28, OSPF (Area 0) is configured between PE1 and PE2 and OSPF (Area 1 and
Area 2) is configured between PEs and CEs. The biggest difference between this configuration and
Configuration 1 is that OSPF is used between the 2 PEs instead of eBGP. Otherwise most of the
configuration is the same as Configuration 1.
Vista de página 404
1 2 ... 400 401 402 403 404 405 406 407 408 409 410 ... 845 846

Comentários a estes Manuais

Sem comentários