Brocade Network OS NETCONF Operations Guide v4.1.1 Manual do Utilizador descarregar pdf (Página 409)

100

101

Network OS NETCONF Operations Guide 377

53-1003231-02

Chapter

Configuring Link Aggregation

In this chapter

•Link aggregation with NETCONF overview . . . . . . . . . . . . . . . . . . . . . . . . . . 377

•Configuring a vLAG . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 377

•Configuring the vLAG ignore split option . . . . . . . . . . . . . . . . . . . . . . . . . . . 380

•LACP configuration and management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 384

Link aggregation with NETCONF overview

This chapter provides procedures for configuring Link Aggregation Group (LAG) and Virtual Link

Aggregation Group (vLAG) using NETCONF interfaces. Refer to the Network OS Administrator’s

Guide for the following related information:

• An overview of what link aggregation is and how it works

• Guidelines for configuring link aggregation groups

• How the Link Aggregation Control Protocol (LACP) works

• An explanation of the supported types of link aggregation: static, dynamic, Brocade proprietary

• An overview of virtual link aggregation

• Configuration guidelines and restrictions

• Troubleshooting tips

Through the NETCONF interface, you can perform the following operations on LAGs and vLAGs:

• Use the <edit-config> RPC to configure a vLAG and LACP.

• Use the <get-port-channel-detail> and <get-portchannel-info-by-intf> custom RPCs to obtain

operational state information about port channels.

• Use the <get-config> RPC to validate configuration settings.

LAG parameters are defined in the brocade-lag YANG module. LACP parameters are defined in

the brocade-lacp YANG module. For details, refer to the Network OS YANG Reference Manual.

Configuring a vLAG

To configure a vLAG, you must configure a port-channel interface on each of the member nodes of

the vLAG. Perform the following steps on each node.

1. Create a LAG that uses two switches within the Brocade VCS Fabric.

When the Brocade VCS Fabric detects that the LAG configuration spans multiple switches, the

LAG automatically becomes a vLAG.

2. Configure each vLAG to treat FCoE MAC addresses as being multi-homed hosts, similar to LAN

traffic.

1 2 ... 404 405 406 407 408 409 410 411 412 413 414 ... 621 622

Comentários a estes Manuais

Sem comentários

Brocade Network OS NETCONF Operations Guide v4.1.1 Manual do Utilizador Página 409

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para Computador Brocade Network OS NETCONF Operations Guide v4.1.1